FAG HS7024-E-T-P4S Angular contact ball bearings
Also known as : HS7024-E-T-P4S
- Inside Diameter: 120 mm
- Outside Diameter: 180 mm
- Width: 28 mm
- Basic dynamic load rating: 46.5 kN
- Basic static load rating: 38.5 kN
FAG HS7024-E-T-P4S
FAG HS7024-E-T-P4S details
| Number | HS7024-E-T-P4S | |
|---|---|---|
| Type | FAG spindle bearings adjusted, in pairs or sets, contact angle a = 25°, restricted tolerances | |
| d | 120 mm | |
| D | 180 mm | |
| B | 28 mm | |
| a | 49 mm | |
| Da | 169 mm | Tolerance: H12 |
| da | 131 mm | Tolerance: h12 |
| Etk max | 146,4 mm | |
| Etk min | 143,3 mm | |
| Etk1 max | 146,4 mm | |
| Etk1 min | 139,2 mm | |
| r1 min | 2 mm | |
| ra max | 2 mm | |
| ra1 max | 1 mm | |
| rmin | 2 mm | |
| α | 25 ° | Contact angle |
| m | 2,32 kg | ≈ Mass |
| Cr | 46500 N | Basic dynamic load rating, radial |
| C0r | 38500 N | Basic static load rating, radial |
| Cur | 3200 N | Fatigue limit load, radial |
| nG Fett | 9500 1/min | Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 14000 1/min | Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 276 N | Preload force |
| FV M | 828 N | Preload force |
| FV H | 1656 N | Preload force |
| KaE L | 795 N | Lift-off force |
| KaE M | 2426 N | Lift-off force |
| KaE H | 4942 N | Lift-off force |
| ca L | 203 N/µm | Axial rigidity |
| ca M | 302 N/µm | Axial rigidity |
| ca H | 392 N/µm | Axial rigidity |
FAG HS7024-E-T-P4S bearing cross reference
30/5-B-2Z-TVH
120 mmx 180 mmx 28 mm
3806-B-2RS-TVH
120 mmx 180 mmx 28 mm
3801-B-2RS-TVH
120 mmx 180 mmx 28 mm
3217-B-2RS-TVH
120 mmx 180 mmx 28 mm
3313-BD-XL
120 mmx 180 mmx 28 mm
3311-BD-XL
120 mmx 180 mmx 28 mm
3310-BD-XL-TVH
120 mmx 180 mmx 28 mm
3310-BD-XL
120 mmx 180 mmx 28 mm
3309-BD-XL
120 mmx 180 mmx 28 mm
3307-BD-XL
120 mmx 180 mmx 28 mm
3306-BD-XL
120 mmx 180 mmx 28 mm
