FAG HSS71900-E-T-P4S Angular contact ball bearings
Also known as : HSS71900-E-T-P4S
- Inside Diameter: 10 mm
- Outside Diameter: 22 mm
- Width: 6 mm
- Basic dynamic load rating: 1.7 kN
- Basic static load rating: 0.62 kN
FAG HSS71900-E-T-P4S
FAG HSS71900-E-T-P4S details
| Number | HSS71900-E-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 25°, lip seals on both sides, non-contact, restricted tolerances |
|
| d | 10 mm | |
| D | 22 mm | |
| B | 6 mm | |
| a | 6,7 mm | |
| Da | 19,5 mm | Tolerance: H12 |
| da | 13 mm | Tolerance: h12 |
| r1 min | 0,3 mm | |
| ra max | 0,3 mm | |
| ra1 max | 0,1 mm | |
| rmin | 0,3 mm | |
| α | 25 ° | Contact angle |
| m | 0,012 kg | ≈ Mass |
| Cr | 1700 N | Basic dynamic load rating, radial |
| C0r | 620 N | Basic static load rating, radial |
| Cur | 64 N | Fatigue limit load, radial |
| nG Fett | 95000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 11 N | Preload force |
| FV M | 32 N | Preload force |
| FV H | 64 N | Preload force |
| KaE L | 31 N | Lift-off force |
| KaE M | 96 N | Lift-off force |
| KaE H | 196 N | Lift-off force |
| ca L | 21,7 N/µm | Axial rigidity |
| ca M | 32,7 N/µm | Axial rigidity |
| ca H | 43 N/µm | Axial rigidity |
FAG HSS71900-E-T-P4S bearing cross reference
30/5-B-2Z-TVH
10 mmx 22 mmx 6 mm
3806-B-2RS-TVH
10 mmx 22 mmx 6 mm
3801-B-2RS-TVH
10 mmx 22 mmx 6 mm
3217-B-2RS-TVH
10 mmx 22 mmx 6 mm
3313-BD-XL
10 mmx 22 mmx 6 mm
3311-BD-XL
10 mmx 22 mmx 6 mm
3310-BD-XL-TVH
10 mmx 22 mmx 6 mm
3310-BD-XL
10 mmx 22 mmx 6 mm
3309-BD-XL
10 mmx 22 mmx 6 mm
3307-BD-XL
10 mmx 22 mmx 6 mm
3306-BD-XL
10 mmx 22 mmx 6 mm
