FAG HS71910-E-T-P4S Angular contact ball bearings
Also known as : HS71910-E-T-P4S
- Inside Diameter: 50 mm
- Outside Diameter: 72 mm
- Width: 12 mm
- Basic dynamic load rating: 9.4 kN
- Basic static load rating: 6.1 kN
FAG HS71910-E-T-P4S
FAG HS71910-E-T-P4S details
| Number | HS71910-E-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 25°, restricted tolerances |
|
| d | 50 mm | |
| D | 72 mm | |
| B | 12 mm | |
| a | 20,2 mm | |
| Da | 67,5 mm | Tolerance: H12 |
| da | 55 mm | Tolerance: h12 |
| Etk max | 59,1 mm | |
| Etk min | 58,2 mm | |
| Etk1 max | 59,1 mm | |
| Etk1 min | 56,4 mm | |
| r1 min | 0,6 mm | |
| ra max | 0,6 mm | |
| ra1 max | 0,15 mm | |
| rmin | 0,6 mm | |
| α | 25 ° | Contact angle |
| m | 0,138 kg | ≈ Mass |
| Cr | 9400 N | Basic dynamic load rating, radial |
| C0r | 6100 N | Basic static load rating, radial |
| Cur | 630 N | Fatigue limit load, radial |
| nG Fett | 24000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 36000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 56 N | Preload force |
| FV M | 169 N | Preload force |
| FV H | 338 N | Preload force |
| KaE L | 163 N | Lift-off force |
| KaE M | 497 N | Lift-off force |
| KaE H | 1014 N | Lift-off force |
| ca L | 81,7 N/µm | Axial rigidity |
| ca M | 122 N/µm | Axial rigidity |
| ca H | 159 N/µm | Axial rigidity |
FAG HS71910-E-T-P4S bearing cross reference
30/5-B-2Z-TVH
50 mmx 72 mmx 12 mm
3806-B-2RS-TVH
50 mmx 72 mmx 12 mm
3801-B-2RS-TVH
50 mmx 72 mmx 12 mm
3217-B-2RS-TVH
50 mmx 72 mmx 12 mm
3313-BD-XL
50 mmx 72 mmx 12 mm
3311-BD-XL
50 mmx 72 mmx 12 mm
3310-BD-XL-TVH
50 mmx 72 mmx 12 mm
3310-BD-XL
50 mmx 72 mmx 12 mm
3309-BD-XL
50 mmx 72 mmx 12 mm
3307-BD-XL
50 mmx 72 mmx 12 mm
3306-BD-XL
50 mmx 72 mmx 12 mm
