FAG HS71905-E-T-P4S Angular contact ball bearings
Also known as : HS71905-E-T-P4S
- Inside Diameter: 25 mm
- Outside Diameter: 42 mm
- Width: 9 mm
- Basic dynamic load rating: 3.65 kN
- Basic static load rating: 1.95 kN
FAG HS71905-E-T-P4S
FAG HS71905-E-T-P4S details
| Number | HS71905-E-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 25°, restricted tolerances |
|
| d | 25 mm | |
| D | 42 mm | |
| B | 9 mm | |
| a | 12,3 mm | |
| Da | 38,5 mm | Tolerance: H12 |
| da | 29 mm | Tolerance: h12 |
| Etk max | 32,2 mm | |
| Etk min | 31,6 mm | |
| Etk1 max | 32,2 mm | |
| Etk1 min | 30,4 mm | |
| r1 min | 0,3 mm | |
| ra max | 0,3 mm | |
| ra1 max | 0,15 mm | |
| rmin | 0,3 mm | |
| α | 25 ° | Contact angle |
| m | 0,046 kg | ≈ Mass |
| Cr | 3650 N | Basic dynamic load rating, radial |
| C0r | 1950 N | Basic static load rating, radial |
| Cur | 201 N | Fatigue limit load, radial |
| nG Fett | 43000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 67000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 23 N | Preload force |
| FV M | 69 N | Preload force |
| FV H | 138 N | Preload force |
| KaE L | 66 N | Lift-off force |
| KaE M | 204 N | Lift-off force |
| KaE H | 416 N | Lift-off force |
| ca L | 42,2 N/µm | Axial rigidity |
| ca M | 63,1 N/µm | Axial rigidity |
| ca H | 82,4 N/µm | Axial rigidity |
FAG HS71905-E-T-P4S bearing cross reference
30/5-B-2Z-TVH
25 mmx 42 mmx 9 mm
3806-B-2RS-TVH
25 mmx 42 mmx 9 mm
3801-B-2RS-TVH
25 mmx 42 mmx 9 mm
3217-B-2RS-TVH
25 mmx 42 mmx 9 mm
3313-BD-XL
25 mmx 42 mmx 9 mm
3311-BD-XL
25 mmx 42 mmx 9 mm
3310-BD-XL-TVH
25 mmx 42 mmx 9 mm
3310-BD-XL
25 mmx 42 mmx 9 mm
3309-BD-XL
25 mmx 42 mmx 9 mm
3307-BD-XL
25 mmx 42 mmx 9 mm
3306-BD-XL
25 mmx 42 mmx 9 mm
