FAG HS7005-E-T-P4S Angular contact ball bearings
Also known as : HS7005-E-T-P4S
- Inside Diameter: 25 mm
- Outside Diameter: 47 mm
- Width: 12 mm
- Basic dynamic load rating: 5.5 kN
- Basic static load rating: 2.8 kN
FAG HS7005-E-T-P4S
FAG HS7005-E-T-P4S details
| Number | HS7005-E-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 25°, restricted tolerances |
|
| d | 25 mm | |
| D | 47 mm | |
| B | 12 mm | |
| a | 14,4 mm | |
| Da | 42 mm | Tolerance: H12 |
| da | 30 mm | Tolerance: h12 |
| Etk max | 34,5 mm | |
| Etk min | 33,6 mm | |
| Etk1 max | 34,5 mm | |
| Etk1 min | 32,2 mm | |
| r1 min | 0,6 mm | |
| ra max | 0,6 mm | |
| ra1 max | 0,3 mm | |
| rmin | 0,6 mm | |
| α | 25 ° | Contact angle |
| m | 0,087 kg | ≈ Mass |
| Cr | 5500 N | Basic dynamic load rating, radial |
| C0r | 2800 N | Basic static load rating, radial |
| Cur | 285 N | Fatigue limit load, radial |
| nG Fett | 40000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 63000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 35 N | Preload force |
| FV M | 104 N | Preload force |
| FV H | 207 N | Preload force |
| KaE L | 100 N | Lift-off force |
| KaE M | 306 N | Lift-off force |
| KaE H | 626 N | Lift-off force |
| ca L | 51,2 N/µm | Axial rigidity |
| ca M | 76,7 N/µm | Axial rigidity |
| ca H | 100 N/µm | Axial rigidity |
FAG HS7005-E-T-P4S bearing cross reference
30/5-B-2Z-TVH
25 mmx 47 mmx 12 mm
3806-B-2RS-TVH
25 mmx 47 mmx 12 mm
3801-B-2RS-TVH
25 mmx 47 mmx 12 mm
3217-B-2RS-TVH
25 mmx 47 mmx 12 mm
3313-BD-XL
25 mmx 47 mmx 12 mm
3311-BD-XL
25 mmx 47 mmx 12 mm
3310-BD-XL-TVH
25 mmx 47 mmx 12 mm
3310-BD-XL
25 mmx 47 mmx 12 mm
3309-BD-XL
25 mmx 47 mmx 12 mm
3307-BD-XL
25 mmx 47 mmx 12 mm
3306-BD-XL
25 mmx 47 mmx 12 mm
