FAG HS71920-C-T-P4S Angular contact ball bearings
Also known as : HS71920-C-T-P4S
- Inside Diameter: 100 mm
- Outside Diameter: 140 mm
- Width: 20 mm
- Basic dynamic load rating: 28.5 kN
- Basic static load rating: 23.5 kN
FAG HS71920-C-T-P4S
FAG HS71920-C-T-P4S details
| Number | HS71920-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 100 mm | |
| D | 140 mm | |
| B | 20 mm | |
| a | 26,1 mm | |
| Da | 133 mm | Tolerance: H12 |
| da | 107 mm | Tolerance: h12 |
| Etk max | 116,9 mm | |
| Etk min | 115,2 mm | |
| Etk1 max | 116,9 mm | |
| Etk1 min | 112,3 mm | |
| r1 min | 1,1 mm | |
| ra max | 0,6 mm | |
| ra1 max | 0,6 mm | |
| rmin | 1,1 mm | |
| α | 15 ° | Contact angle |
| m | 0,86 kg | ≈ Mass |
| Cr | 28500 N | Basic dynamic load rating, radial |
| C0r | 23500 N | Basic static load rating, radial |
| Cur | 2200 N | Fatigue limit load, radial |
| nG Fett | 13000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 20000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 97 N | Preload force |
| FV M | 291 N | Preload force |
| FV H | 583 N | Preload force |
| KaE L | 289 N | Lift-off force |
| KaE M | 906 N | Lift-off force |
| KaE H | 1883 N | Lift-off force |
| ca L | 64,6 N/µm | Axial rigidity |
| ca M | 101 N/µm | Axial rigidity |
| ca H | 137 N/µm | Axial rigidity |
FAG HS71920-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
100 mmx 140 mmx 20 mm
3806-B-2RS-TVH
100 mmx 140 mmx 20 mm
3801-B-2RS-TVH
100 mmx 140 mmx 20 mm
3217-B-2RS-TVH
100 mmx 140 mmx 20 mm
3313-BD-XL
100 mmx 140 mmx 20 mm
3311-BD-XL
100 mmx 140 mmx 20 mm
3310-BD-XL-TVH
100 mmx 140 mmx 20 mm
3310-BD-XL
100 mmx 140 mmx 20 mm
3309-BD-XL
100 mmx 140 mmx 20 mm
3307-BD-XL
100 mmx 140 mmx 20 mm
3306-BD-XL
100 mmx 140 mmx 20 mm
