FAG HS71916-C-T-P4S Angular contact ball bearings
Also known as : HS71916-C-T-P4S
- Inside Diameter: 80 mm
- Outside Diameter: 110 mm
- Width: 16 mm
- Basic dynamic load rating: 20.3 kN
- Basic static load rating: 15.5 kN
FAG HS71916-C-T-P4S
FAG HS71916-C-T-P4S details
| Number | HS71916-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 80 mm | |
| D | 110 mm | |
| B | 16 mm | |
| a | 20,7 mm | |
| Da | 104 mm | Tolerance: H12 |
| da | 86 mm | Tolerance: h12 |
| Etk max | 92,5 mm | |
| Etk min | 91 mm | |
| Etk1 max | 92,5 mm | |
| Etk1 min | 88,5 mm | |
| r1 min | 1 mm | |
| ra max | 0,6 mm | |
| ra1 max | 0,3 mm | |
| rmin | 1 mm | |
| α | 15 ° | Contact angle |
| m | 0,379 kg | ≈ Mass |
| Cr | 20300 N | Basic dynamic load rating, radial |
| C0r | 15500 N | Basic static load rating, radial |
| Cur | 1590 N | Fatigue limit load, radial |
| nG Fett | 17000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 26000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 71 N | Preload force |
| FV M | 213 N | Preload force |
| FV H | 426 N | Preload force |
| KaE L | 212 N | Lift-off force |
| KaE M | 666 N | Lift-off force |
| KaE H | 1385 N | Lift-off force |
| ca L | 52,3 N/µm | Axial rigidity |
| ca M | 81,9 N/µm | Axial rigidity |
| ca H | 112 N/µm | Axial rigidity |
FAG HS71916-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
80 mmx 110 mmx 16 mm
3806-B-2RS-TVH
80 mmx 110 mmx 16 mm
3801-B-2RS-TVH
80 mmx 110 mmx 16 mm
3217-B-2RS-TVH
80 mmx 110 mmx 16 mm
3313-BD-XL
80 mmx 110 mmx 16 mm
3311-BD-XL
80 mmx 110 mmx 16 mm
3310-BD-XL-TVH
80 mmx 110 mmx 16 mm
3310-BD-XL
80 mmx 110 mmx 16 mm
3309-BD-XL
80 mmx 110 mmx 16 mm
3307-BD-XL
80 mmx 110 mmx 16 mm
3306-BD-XL
80 mmx 110 mmx 16 mm
