FAG HS71907-C-T-P4S Angular contact ball bearings
Also known as : HS71907-C-T-P4S
- Inside Diameter: 35 mm
- Outside Diameter: 55 mm
- Width: 10 mm
- Basic dynamic load rating: 6.4 kN
- Basic static load rating: 3.8 kN
FAG HS71907-C-T-P4S
FAG HS71907-C-T-P4S details
| Number | HS71907-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 35 mm | |
| D | 55 mm | |
| B | 10 mm | |
| a | 11 mm | |
| Da | 51,5 mm | Tolerance: H12 |
| da | 40 mm | Tolerance: h12 |
| Etk max | 43,4 mm | |
| Etk min | 42,6 mm | |
| Etk1 max | 43,4 mm | |
| Etk1 min | 41,2 mm | |
| r1 min | 0,6 mm | |
| ra max | 0,6 mm | |
| ra1 max | 0,15 mm | |
| rmin | 0,6 mm | |
| α | 15 ° | Contact angle |
| m | 0,081 kg | ≈ Mass |
| Cr | 6400 N | Basic dynamic load rating, radial |
| C0r | 3800 N | Basic static load rating, radial |
| Cur | 390 N | Fatigue limit load, radial |
| nG Fett | 36000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 56000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 23 N | Preload force |
| FV M | 70 N | Preload force |
| FV H | 140 N | Preload force |
| KaE L | 70 N | Lift-off force |
| KaE M | 220 N | Lift-off force |
| KaE H | 459 N | Lift-off force |
| ca L | 24,5 N/µm | Axial rigidity |
| ca M | 38,6 N/µm | Axial rigidity |
| ca H | 53 N/µm | Axial rigidity |
FAG HS71907-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
35 mmx 55 mmx 10 mm
3806-B-2RS-TVH
35 mmx 55 mmx 10 mm
3801-B-2RS-TVH
35 mmx 55 mmx 10 mm
3217-B-2RS-TVH
35 mmx 55 mmx 10 mm
3313-BD-XL
35 mmx 55 mmx 10 mm
3311-BD-XL
35 mmx 55 mmx 10 mm
3310-BD-XL-TVH
35 mmx 55 mmx 10 mm
3310-BD-XL
35 mmx 55 mmx 10 mm
3309-BD-XL
35 mmx 55 mmx 10 mm
3307-BD-XL
35 mmx 55 mmx 10 mm
3306-BD-XL
35 mmx 55 mmx 10 mm
