FAG HS71901-C-T-P4S Angular contact ball bearings
Also known as : HS71901-C-T-P4S
- Inside Diameter: 12 mm
- Outside Diameter: 24 mm
- Width: 6 mm
- Basic dynamic load rating: 1.85 kN
- Basic static load rating: 0.72 kN
FAG HS71901-C-T-P4S
FAG HS71901-C-T-P4S details
| Number | HS71901-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 12 mm | |
| D | 24 mm | |
| B | 6 mm | |
| a | 5,4 mm | |
| Da | 21,5 mm | Tolerance: H12 |
| da | 15 mm | Tolerance: h12 |
| Etk max | 17 mm | |
| Etk min | 16,6 mm | |
| Etk1 max | 17 mm | |
| Etk1 min | 15,7 mm | |
| r1 min | 0,3 mm | |
| ra max | 0,3 mm | |
| ra1 max | 0,1 mm | |
| rmin | 0,3 mm | |
| α | 15 ° | Contact angle |
| m | 0,011 kg | ≈ Mass |
| Cr | 1850 N | Basic dynamic load rating, radial |
| C0r | 720 N | Basic static load rating, radial |
| Cur | 74 N | Fatigue limit load, radial |
| nG Fett | 90000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 140000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 7 N | Preload force |
| FV M | 21 N | Preload force |
| FV H | 41 N | Preload force |
| KaE L | 21 N | Lift-off force |
| KaE M | 66 N | Lift-off force |
| KaE H | 137 N | Lift-off force |
| ca L | 9,4 N/µm | Axial rigidity |
| ca M | 15 N/µm | Axial rigidity |
| ca H | 20,8 N/µm | Axial rigidity |
FAG HS71901-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
12 mmx 24 mmx 6 mm
3806-B-2RS-TVH
12 mmx 24 mmx 6 mm
3801-B-2RS-TVH
12 mmx 24 mmx 6 mm
3217-B-2RS-TVH
12 mmx 24 mmx 6 mm
3313-BD-XL
12 mmx 24 mmx 6 mm
3311-BD-XL
12 mmx 24 mmx 6 mm
3310-BD-XL-TVH
12 mmx 24 mmx 6 mm
3310-BD-XL
12 mmx 24 mmx 6 mm
3309-BD-XL
12 mmx 24 mmx 6 mm
3307-BD-XL
12 mmx 24 mmx 6 mm
3306-BD-XL
12 mmx 24 mmx 6 mm
