FAG HS71900-C-T-P4S Angular contact ball bearings
Also known as : HS71900-C-T-P4S
- Inside Diameter: 10 mm
- Outside Diameter: 22 mm
- Width: 6 mm
- Basic dynamic load rating: 1.79 kN
- Basic static load rating: 0.65 kN
FAG HS71900-C-T-P4S
FAG HS71900-C-T-P4S details
| Number | HS71900-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 10 mm | |
| D | 22 mm | |
| B | 6 mm | |
| a | 5,1 mm | |
| Da | 19,5 mm | Tolerance: H12 |
| da | 13 mm | Tolerance: h12 |
| Etk max | 15 mm | |
| Etk min | 14,6 mm | |
| Etk1 max | 15 mm | |
| Etk1 min | 13,7 mm | |
| r1 min | 0,3 mm | |
| ra max | 0,3 mm | |
| ra1 max | 0,1 mm | |
| rmin | 0,3 mm | |
| α | 15 ° | Contact angle |
| m | 0,01 kg | ≈ Mass |
| Cr | 1790 N | Basic dynamic load rating, radial |
| C0r | 650 N | Basic static load rating, radial |
| Cur | 67 N | Fatigue limit load, radial |
| nG Fett | 100000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 160000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 7 N | Preload force |
| FV M | 20 N | Preload force |
| FV H | 39 N | Preload force |
| KaE L | 20 N | Lift-off force |
| KaE M | 63 N | Lift-off force |
| KaE H | 132 N | Lift-off force |
| ca L | 8,8 N/µm | Axial rigidity |
| ca M | 14,1 N/µm | Axial rigidity |
| ca H | 19,6 N/µm | Axial rigidity |
FAG HS71900-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
10 mmx 22 mmx 6 mm
3806-B-2RS-TVH
10 mmx 22 mmx 6 mm
3801-B-2RS-TVH
10 mmx 22 mmx 6 mm
3217-B-2RS-TVH
10 mmx 22 mmx 6 mm
3313-BD-XL
10 mmx 22 mmx 6 mm
3311-BD-XL
10 mmx 22 mmx 6 mm
3310-BD-XL-TVH
10 mmx 22 mmx 6 mm
3310-BD-XL
10 mmx 22 mmx 6 mm
3309-BD-XL
10 mmx 22 mmx 6 mm
3307-BD-XL
10 mmx 22 mmx 6 mm
3306-BD-XL
10 mmx 22 mmx 6 mm
