FAG HS7013-C-T-P4S Angular contact ball bearings
Also known as : HS7013-C-T-P4S
- Inside Diameter: 65 mm
- Outside Diameter: 100 mm
- Width: 18 mm
- Basic dynamic load rating: 19.3 kN
- Basic static load rating: 13.4 kN
FAG HS7013-C-T-P4S
FAG HS7013-C-T-P4S details
| Number | HS7013-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 65 mm | |
| D | 100 mm | |
| B | 18 mm | |
| a | 20,1 mm | |
| Da | 93 mm | Tolerance: H12 |
| da | 72 mm | Tolerance: h12 |
| Etk max | 80,2 mm | |
| Etk min | 78,5 mm | |
| Etk1 max | 80,2 mm | |
| Etk1 min | 75,9 mm | |
| r1 min | 1,1 mm | |
| ra max | 1 mm | |
| ra1 max | 0,6 mm | |
| rmin | 1,1 mm | |
| α | 15 ° | Contact angle |
| m | 0,461 kg | ≈ Mass |
| Cr | 19300 N | Basic dynamic load rating, radial |
| C0r | 13400 N | Basic static load rating, radial |
| Cur | 1380 N | Fatigue limit load, radial |
| nG Fett | 19000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 30000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 67 N | Preload force |
| FV M | 201 N | Preload force |
| FV H | 402 N | Preload force |
| KaE L | 200 N | Lift-off force |
| KaE M | 630 N | Lift-off force |
| KaE H | 1312 N | Lift-off force |
| ca L | 47,4 N/µm | Axial rigidity |
| ca M | 74,4 N/µm | Axial rigidity |
| ca H | 102 N/µm | Axial rigidity |
FAG HS7013-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
65 mmx 100 mmx 18 mm
3806-B-2RS-TVH
65 mmx 100 mmx 18 mm
3801-B-2RS-TVH
65 mmx 100 mmx 18 mm
3217-B-2RS-TVH
65 mmx 100 mmx 18 mm
3313-BD-XL
65 mmx 100 mmx 18 mm
3311-BD-XL
65 mmx 100 mmx 18 mm
3310-BD-XL-TVH
65 mmx 100 mmx 18 mm
3310-BD-XL
65 mmx 100 mmx 18 mm
3309-BD-XL
65 mmx 100 mmx 18 mm
3307-BD-XL
65 mmx 100 mmx 18 mm
3306-BD-XL
65 mmx 100 mmx 18 mm
