FAG HS7010-C-T-P4S Angular contact ball bearings
Also known as : HS7010-C-T-P4S
- Inside Diameter: 50 mm
- Outside Diameter: 80 mm
- Width: 16 mm
- Basic dynamic load rating: 12.8 kN
- Basic static load rating: 8.2 kN
FAG HS7010-C-T-P4S
FAG HS7010-C-T-P4S details
| Number | HS7010-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 50 mm | |
| D | 80 mm | |
| B | 16 mm | |
| a | 16,7 mm | |
| Da | 74 mm | Tolerance: H12 |
| da | 56 mm | Tolerance: h12 |
| Etk max | 63 mm | |
| Etk min | 61,7 mm | |
| Etk1 max | 63 mm | |
| Etk1 min | 59,6 mm | |
| r1 min | 1 mm | |
| ra max | 1 mm | |
| ra1 max | 0,3 mm | |
| rmin | 1 mm | |
| α | 15 ° | Contact angle |
| m | 0,283 kg | ≈ Mass |
| Cr | 12800 N | Basic dynamic load rating, radial |
| C0r | 8200 N | Basic static load rating, radial |
| Cur | 840 N | Fatigue limit load, radial |
| nG Fett | 24000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 38000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 45 N | Preload force |
| FV M | 135 N | Preload force |
| FV H | 269 N | Preload force |
| KaE L | 135 N | Lift-off force |
| KaE M | 424 N | Lift-off force |
| KaE H | 884 N | Lift-off force |
| ca L | 36,4 N/µm | Axial rigidity |
| ca M | 57,4 N/µm | Axial rigidity |
| ca H | 78,8 N/µm | Axial rigidity |
FAG HS7010-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
50 mmx 80 mmx 16 mm
3806-B-2RS-TVH
50 mmx 80 mmx 16 mm
3801-B-2RS-TVH
50 mmx 80 mmx 16 mm
3217-B-2RS-TVH
50 mmx 80 mmx 16 mm
3313-BD-XL
50 mmx 80 mmx 16 mm
3311-BD-XL
50 mmx 80 mmx 16 mm
3310-BD-XL-TVH
50 mmx 80 mmx 16 mm
3310-BD-XL
50 mmx 80 mmx 16 mm
3309-BD-XL
50 mmx 80 mmx 16 mm
3307-BD-XL
50 mmx 80 mmx 16 mm
3306-BD-XL
50 mmx 80 mmx 16 mm
